TEL: +86-595-82050111
Categories
Contact Us
TEL: +86-18859777755
FAX: +86-595-82006151
E-mail: hicreate@jubao.cc
ADD: Hi-Create Factory, Xidong Industrial Zone, Luoyang, Huian, Quanzhou, Fujian, China

Mobile 2D code:
Knowledge
Home > Knowledge > Content
What causes a decline in the production capacity of the facial tissue paper machine?
Jan 05, 2018

facial-tissue-machine-a59258476864.jpg

If you are a facial tissue manufacturer and you feel that the productivity of the facial tissue machine is decreasing, then you need to be vigilant. Checking the following points to know whether there is something wrong with it.

  1. The slag yield?may be too low (especially for dirtier pulp stuff).

  2. You should confirm whether there is air in paper pulp.

  3. The sieve opening is too small (or the opening's area is too larger).

  4. The entrance's consistence?is too high or low - -so you regulate it to the recommended level 

  5. To check the facial tissue machine's incoming?pulp pressure-- if it is so low , it need to be adjusted. 

  6. The sieve is not completely full -- so you should check whether there is a partial vacuum.

  7.The excessive internal dilution will reduce the pass rate.So it need to be adjusted if necessary.

  8.If the good pulp valve's opening is too small -- You can checking whether there is production capacity limitation in the sequence section.

  9.If the entrance's condition is unstable -- You can stabilize the sieving slurry flow. 

  Welcome to call, and you can also visit the 

 to know more things.


  • Contact Us
    TEL: +86-18859777755
    FAX: +86-595-82006151
    E-mail: hicreate@jubao.cc
    ADD: Hi-Create Factory, Xidong Industrial Zone, Luoyang, Huian, Quanzhou, Fujian, China

    Mobile 2D code:
  • Categories
  • Copyright © Quanzhou Hi-Create Machine Co.,Ltd All Rights Reserved.